Material Safety Data Sheet (MSDS)

• Fragonia™ Oil –

IDENTIFICATION

Product Name: Oil of Agonis fragrans.

Synonyms: Fragonia™ Oil

Production Process: obtained by steam distillation of terminal branches of Agonis fragrans

UN No: 1993

Proper Shipping Name: “Flammable Liquid nos Fragonia™ Oil.”

Hazchem Code: 3[Y]E

Dangerous Goods: Class 3 Flammable

Poison Schedule: S6

Product Type: Organic liquid

Supplier: Essential Oils Direct Po Box 161 Oldham OL2 6FA

Emergency Tel No:  0161 633 3952 Emergency Contact:  Mr. David Freer.

Full MSDS library can be found at http://www.essentialoilsdirect.co.uk/msds  

PHYSICAL AND CHEMICAL PROPERTIES

Physical State: Liquid

Colour: Colourless to pale yellow

Odour: fresh cineolic odour with slight spicy cinnamon tonality and sweet balsamic undertones

Specific Gravity: 0.82 to 0.9

Solubility (Water): Negligible

Corrosiveness: Not corrosive

Chemical Composition: Essential oil typically containing terpene hydrocarbons, 1.8-cineole (26-33%), a-pinene (22-27%), Linalool (10-13%) and a-terpineol (5-8%) 

REGULATORY REFERENCES

Class 3 Flammable Dangerous Good 

FLAMABILITY AND EXPLOSIVE PROPERTIES

Flash Point (Closed Cup): 46 ºC 

Fire Extinguishing Data: Carbon Dioxide, Dry Chemical, Foam.

Special Fire fighting Procedures: None known.

Unusual Fire and Explosion Hazards: Heat may cause violent rupture of containers if involved in a fire. When heated to decomposition will produce acrid smoke and fumes. 

TOXICITY AND HEALTH DATA

Ingestion: Not available. Contains greater than 25% cineole. Could cause adverse respiratory problems due to volatility.

Medical Conditions Aggravated By Overexposure: None Known

Eye contact: a severe irritant.

Dermal Toxicity: No known toxicity if applied topically.  

FIRST AID PROCEDURES

Ingestion: If poisoning occurs, get to a doctor or hospital quickly. If swallowed do not induce vomiting, give a glass of water.

Eye Contact: Flush with plenty of water. Seek medical advice

Skin Contact: Wash with warm soapy water

REACTIVITY DATA

Stability: Stable

Hazardous Polymerisation: Unknown

Conditions to Avoid: Heat and light 
 
 

SPILL AND DISPOSAL PROCEDURES

In Event of Spill or Discharge: Cover with absorbent media such as diatomite, sweep up and dispose of in accordance with all applicable Federal, State and Local environmental regulations 

PERSONNEL PROTECTION PROCEDURES

Ventilation: Good room ventilation Local exhaust fan optional

Respiratory: None required where adequate ventilation exists

Eye Protection: Safety glasses optional

Skin Protection: Suitable gloves optional 

TRANSPORT, STORAGE AND HANDLING PROCEDURES

This material is classed in Australia as UN 1993, Class 3 flammable.

This material is classed in Australia as an S6 Poison.

Containers: Metal with screw top lids preferred. HDPE plastic suitable for short term  

FURTHER INFORMATION

The above information is based on test data obtained by the grower, and other material available in the public domain. The grower believes the information is accurate and reliable, however it is provided for the user’s investigation and verification only. It is not suggested that these hazard precautions are the only ones which exist. The grower does not make any warranty whatsoever with respect to the information contained, and by using the information the user undertakes not to hold the grower liable or responsible in any way whatsoever in relation or consequential to such use. It is the responsibility of the user to observe all applicable laws, rules, acts and regulations.  

DECLARATION OF ALLERGENS 

……………………

Daniel Todd